Epson PowerLite 5000 - Removing the Filter Board

EPSON PowerLite 5000 Service Manual
3-25
3.2.18 Removing the Filter Board
Prerequisite conditions: 3.2.3/3.2.4/3.2.8/3.2.12/3.2.13/3.2.17
Figure 3-32
1. Unplug the Fast-on tab cable (black wire and white wire) from the filter board.
2. Remove the 4 mounting screws.
Screws: +M3×8 F/ZN Bind: P/N 1021824
(mounting torque: 6.0 kg. cm = 5.2 lb. inch)
3. Pull up the filter board holding plate.
4. Remove the cables from the cable clamp.
5. Remove the filter board from the lower case.
Caution:
When installing the filter board, arrange the cables in the clamp and cable guide.
Screws
Fast-on tab cable (Black wire
and white wire)