Epson PowerLite 5000 - Removing the Lamp Thermistor

EPSON PowerLite 5000 Service Manual
3-22
PBS Thermistor
1. Remove the cable clamp screw mounting the PBS thermistor to the power supply unit
chassis.
2. Separate the PBS thermistor from the cable clamp.
3. Disconnect the cable from connector CN860 on the main board.
3.2.14 Removing the Lamp Thermistor
Prerequisite conditions: 3.2.3/3.2.4/3.2.8/3.2.13
PBS Thermistor
Lamp Thermistor
Figure 3-27
Figure 3-28