SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B
ADJUSTMENT CR Related Adjustments 235
Confidential
8. Press [MEASURE] on the tensimeter and flip the belt with tweezers or a similar
tool.
9. Measure the belt tension for three times, and check if the average is within the
standards.
Within the standards: Go to Step 10
Out of the standards: Go to Step 12
10. Click [Finish].
11. Turn the printer OFF to finish the adjustment.
Figure 4-15. Measuring the belt tension
C A U T I O N
Be sure to measure the tension of the belt on the upper side. If
you measure the tension of the belt on the lower side, the
measuring value may be inaccurate.
Flip the belt as weak as the tensimeter can measure it.
Be careful not to let the microphone touch the belt when
flipping the belt.
Center
(Measurement
point)
CR UNIT
Driven pulley
Measuring microphone
Upper timing belt
To Next Page
Loading...
Need help?
General