Epson SC-T7000 series

SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 143
Confidential
3.4.4.10 CR HP SENSOR
1. Remove the UPPER LEFT COVER. (p100)
2. Remove the UPPER SUPPORT R COVER. (p94)
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER. (p95)
6. Unlock the CR UNIT. (p83)
7. Move the CR UNIT on the Platen.
8. Disengage the hooks, and remove the CR HP SENSOR.
9. Disconnect the cable from the CR HP SENSOR.
Figure 3-89. Removing the CR HP SENSOR
Hook
CR HP SENSOR
Connector
Cable