Epson SC-T7000 series User Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B
ADJUSTMENT Media Feed Related Checks and Adjustments 268
Confidential
20. With the paper presser being released, check that the control panel displays “01”.
When the displayed value is other than “01”, carry out the adjustment. → Go to
ADJUSTMENT PROCEDURE.
21. After checking and adjusting, check again all the condition is correct.
Figure 4-66. Setting position of the adjustment jig
ADJUSTMENT PROCEDURE
When the least significant digit of the value differ from the standard value, adjust the
paper thickness sensor holder 2 (left side) position, and when the second digit from the
least significant digit of the value differ from the standard value, adjust the paper
thickness sensor holder (right side) position.
1. Loosen the screws (one each) that secure the paper thickness sensor holder.
2. Slide the paper thickness sensor holder forward and backward checking the panel
display, and hold the position of the paper thickness sensor holder at the
immediate after the position that the panel display is switched.
3. Secure the screws to fix the paper thickness sensor holder.
Figure 4-67. Adjusting the Positions
Adjustment jig
Setting direction
Align this end with
the stepped end of
the platen.
Align the right end with the 1st
row of the pressure roller
C H E C K
P O I N T
Slide the paper thickness sensor holder forward to raise the value
and backward it to decrease the value.
Paper thickness sensor holder 2
Screws
Paper thickness sensor holder 1

Epson SC-T7000 series Specifications

General

Brand	Epson
Model	SC-T7000 series
Category	Printer
Language	English