1-2
Paper Handling
Loading Plain Paper
Follow the steps below to load plain paper in the printer.
1. Lower the output tray and slide out the extension. Next, slide
theleftedgeguidesothatthedistancebetweentheedge
guides is slightly wider than the width of your paper.
2. Fan a stack of paper, then tap it on a flat surface to even the
edges.
3. Load the stack of paper in the sheet feeder with the printable
side up and the right edge of the paper resting against the
right edge guide. Then slide the left edge guide against the
left edge of the paper.
Note:
❏ Always load paper into the sheet feeder short edge first.
❏ Make sure the paper stack fits under the arrow mark inside the
edge guide.
To Next Page
Loading...
Need help?
General