Using the Printer Software for Windows
2-37
Note:
You may not be able to use DMA transfer on some computers even
after you make the settings explained above. Consult your computer
maker for information on the DMA transfer capability of your
computer.
Using Port Configuration (Windows NT 4.0 only)
Note:
Port settings for Windows NT 4.0 are complicated and should only be
made by an experienced person with administrative privileges.
If your computer has a parallel port that supports ECP mode, you
can make certain print speed settings in the Port Configuration
dialog box. Before making settings, make sure that ECP mode has
been selected in your computer settings. For details about ECP
mode, see your computer manual.
To access the Port Configuration dialog box, click the Start button,
point to Settings,andclickPrinters. Then select your printer and
click Properties on the File menu. The printer driver opens. Click
the Ports tab, then click Configure Port. The following dialog box
appears.
To Next Page
Loading...
Need help?
General