EPSON Stylus Color 980 Revision A
Disassembly and Assembly Disassembly Procedures 118
r
CHECK
POINT
Before assembling the ASF, ensure the following four
parts are correctly mounted onto the paper loading
assembly.
- One Torsion spring
- One extension spring
- One compression spring
- One rod spring
Figure 4-30. Parts in Paper Loading Assembly
When installing the paper loading assembly, set the
edge whose narrow portion is longer than the other to
the right.
Extension S pring
Paper Loading A ssem bly
C om pression S pring 1.66
Torsion Spring
Rod Spring
When installing the LD roller shaft with the both paper loading
assemblies on it into the ASF frame, shift the right paper
loading assembly to the right edge of the ASF frame, then fix it
by aligning the groove in the back of the paper loading
assembly with the rail ribs on the inner side of the ASF frame.
Fix the left paper loading assembly also by aligning it with the
rail ribs on the inner side of the ASF frame. The left paper
loading assembly, however, moves freely from left to right or
vice versa.
Figure 4-31. LD Roller Shaft Installation
ASF Fram e
Paper Loading
To Next Page
Loading...
