Epson Stylus CX4300 - Page 35

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 35
Note : “–” : No change
Table 3-4. Error Indications and Fault Occurrence Causes
Printer Status Replace Ink Cartridge or No Ink Cartridge CSIC Error Incorrect I/C Paper Jam
Indications
Power — — — —
Ink On On On —
Paper — — — On
Status monitor 3
message
Fault
Occurrence
Cause
This error is detected when;
• The ink consumption amount reaches
100%.
• The ink cartridge is defective.
Note :
The slight amount of the ink is remaining in the
I/C even if the Replace Ink Cartridge error is
detected. This is to prevent the Print Head
nozzle from the printing operation without
firing the ink.
This error is detected when data from
CSIC cannot be read normally or when
data cannot be written to CSIC.
This error is detected when;
• An unsupported ink cartridge has been
installed.
• An ink cartridge with a different
destination has been installed.
This error is detected when the PE Sensor
cannot properly detect the paper bottom
edge during feeding of paper.
Reference Page
Table 3-10, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 43
Table 3-10, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 43
Table 3-10, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 43
Table 3-11, “Check point for paper jam
error according to each phenomenon,” on
page 44