Rev.D Assembly and Disassembly 2-75
TM-U675/U675P (with autocutter) Service Manual
Confidential
Note:
Perform the following steps only if your printer does not have a MICR unit.
51. Attach the paper feed motor to the main frame with two screws. Check that the circuit
board side of the motor is facing downward as shown in the illustration.
Figure 2-75
739 Paper feed motor
726 Screw (C.B.S-tite F, 3X6)
726 Screw (C.B.S-tite F, 3X6)
To Next Page
Loading...
