2-10 Assembly and Disassembly Rev.D
Confidential
3. Attach the MICR fixing sheet to the MICR fixing. Set the hole on the MICR fixing sheet over
the MICR fixing nib and attach so that the MICR fixing sheet does not protrude from the
MICR fixing.
4. Attach the MICR fixing to the MICR lever. The tabs on the MICR fixing should fit into the
MICR grooves.
5. Assemble by inserting the MICR roller shaft. (Attach the shaft with one E-ring.)
Figure 2-9
777 MICR roller shaft
Hole
Nibs
Tabs
Looking directly from the bottom
778 E-ring (1.2)
787 MICR lever
791 MICR fixing sheet
788 MICR fixing
To Next Page
Loading...
