Rev.D Assembly and Disassembly 2-11
TM-U675/U675P (with autocutter) Service Manual
Confidential
6. Insert the two MICR lever guide shafts into the MICR frame, starting with the end with the
smaller diameter.
7. Lubricate the areas where the MICR lever and the MICR frame are in contact (six places).
8. Attach the MICR frame to the MICR lever as shown in the drawing.
Figure 2-10
G-47
G-47
G-47
796 MICR lever guide shaft
792 MICR frame assembly
787 MICR lever
To Next Page
Loading...
