Epson TM-U675 - Page 53

Rev.D Assembly and Disassembly 2-19
TM-U675/U675P (with autocutter) Service Manual
Confidential
8. Insert the carriage drive transmission gear into the shaft shown in the figure below.
9. Insert the ribbon reduction gear into the shaft shown in the figure below.
10. Insert the ribbon intermediate gear into the shaft shown in the figure below. The smaller
diameter ribbon intermediate gear should be on the lower side.
11. Attach the ribbon drive plate assembly above the ribbon reduction gear and the ribbon
intermediate gear. Set the gear side of the ribbon drive plate assembly downward.
12. Attach the gear train cover to the carriage drive transmission gear.
13. Fasten the belt drive cap, carriage drive transmission gear, and ribbon drive plate assembly
with three E-rings.
Figure 2-18
720
E-ring (2)
720
E-ring (2)
706
Ribbon drive plate assembly
634 Carriage drive transmission gear
768
Gear train cover
682
Ribbon reduction gear
683 Ribbon intermediate gear
720 E-ring (2)
Carriage frame sub assembly