Epson TM-U675 - Page 56

2-22 Assembly and Disassembly Rev.D
Confidential
22. Align the intermediate circuit board assembly to the carriage frame sub assembly with two
dowels, and attach the intermediate circuit board cover.
23. Tighten the intermediate circuit board assembly and intermediate circuit board cover
together with two screws.
24. Attach the H. P. detector assembly to the carriage frame sub assembly with one screw. Pass
the H. P. detector assembly lead wires to the bottom through the hole in the carriage frame
sub assembly.
Figure 2-21
775
Screw (C.P.S-tite(P4), 3x6)
775 Screw (C.P.S-tite(P4), 3x6)
769
Intermediate circuit board cover
708
Intermediate
circuit board assembly
775 Screw (C.P.S-tite(P4), 3x6)
707 H.P. detector assembly
688
Carriage
frame sub
assembly