Rev.D Assembly and Disassembly 2-23
TM-U675/U675P (with autocutter) Service Manual
Confidential
25. Pass the flexible plastic cable (FPC) for the print head unit (Eb) through the slit in the
carriage assembly. When you do this, the FPC should be below the two hooks on the
carriage assembly. Install the print head unit (Eb) onto the carriage assembly. Connect the
FPC to the intermediate circuit board assembly connector.
26. Attach the nose guide on the print head unit (Eb) while aligning the three nibs. Secure the
nose guide with one screw.
27. Attach the head seal to the print head unit (Eb).
28. Lubricate the carriage motor gear and the top of the E-ring fastening the ribbon drive plate
assembly.
Figure 2-22
Figure 2-23
608
Screw (C.P.P-tite, 3X12)
623
Nose guide
689
Print head unit (Eb)
FPC
Slit
Hooks
G-36
G-36
FPC
795
Head seal
689
Print head unit (Eb)
FPC
709 Carriage assembly
688
Carriage frame sub assembly
708
Intermediate circuit board assembly
To Next Page
Loading...
