Rev.D Assembly and Disassembly 2-35
TM-U675/U675P (with autocutter) Service Manual
Confidential
15. Insert the slip feed roller holder into the slip feed roller.
16. Attach the slip feed roller to the platen lever assembly with one E-ring. Insert the pin-
shaped nib of the slip feed roller holder into the third hole from the left on the platen lever
assembly.
17. Push the slip drive gear into the slip feed roller from the side with the larger diameter.
18. Apply lubrication to both sides of the slip feed roller and the slip feed roller holder. Rotate
the roller several times to allow the oil to work its way completely around.
Figure 2-35
G-48
G-48
72 E-ring (3)
668
Slip feed roller
668
659
Slip feed roller holder
624 Platen lever assembly
649 Slip drive gear
To Next Page
Loading...
