Rev.D Assembly and Disassembly 2-47
TM-U675/U675P (with autocutter) Service Manual
Confidential
2. Apply G-36 oil to the cutter worm gear (part touching the frame).
3. Attach the cutter worm gear, autocutter deceleration gear, clutch washer, and cutter clutch
spring to the cutter cover sub assembly. When doing so, the narrow side of the cutter clutch
spring is the motor side.
4. Insert and touch the autocutter deceleration shaft from the hole in the motor side.
Figure 2-47
G-36
188 Cutter cover sub assembly
183 Autocutter deceleration shaft
184 Cutter worm gear
185 Clutch washer
186 Cutter clutch spring
182 Autocutter deceleration gear
To Next Page
Loading...
