2-48 Assembly and Disassembly Rev.D
Confidential
5. Attach the cutter motor assembly to the cutter cover sub assembly (screw in 1 place). Attach
in the direction from which you can see the label of the cutter motor assembly from the
cutter cover sub assembly window.
6. Attach the micro switch to the cutter cover sub assembly in the direction shown in the figure
(screw in 1 place).
7. Hang the lead wire of the motor and micro switch onto the parts shown in the figure.
Figure 2-48
187
Switch screw
Hang the lead wire of the micro switch
Hang the lead wire of the motor
181
Screw (C.B., 2X2.5)
119
Micro switch
191 Cutter motor assembly
To Next Page
Loading...
