Rev.D Assembly and Disassembly 2-49
TM-U675/U675P (with autocutter) Service Manual
Confidential
8. Apply G-36 oil to the area of the autocutter deceleration gear and the motor gear that are
touching.
9. Apply G-36 oil to the area of the cutter clutch spring and cutter cover sub assembly that are
touching.
10. Apply G-36 oil to the autocutter deceleration shaft from the gap in the cutter clutch spring.
11. Apply G-36 oil to the two places on the cutter worm gear and cutter cover sub assembly that
are touching.
Figure 2-49
G-36
G-36
G-36
G-36
Step 8.
Step 11.
Step 10.
Step 9.
186 Cutter clutch spring
184 Cutter worm gear
182 Autocutter deceleration gear
183 Autocutter deceleration shaft
To Next Page
Loading...
