2-50 Assembly and Disassembly Rev.D
Confidential
12. Apply G-36 oil to the axis that the cutter drive gear assembly fits.
13. Attach the cutter drive gear assembly (1 plain washer; 1 E-ring). Position the cavity in the
cutter drive gear assembly with the actuator of the micro switch.
14. Apply G-36 oil around the entire circumference of the gear for the cutter drive gear
assembly.
Figure 2-50
180 E-ring (2.5)
Actuator
Cavity
193 Plain washer (3X0.5X7)
189 Cutter drive gear
assembly
G-36
G-36
To Next Page
Loading...
