Rev.D Assembly and Disassembly 2-61
TM-U675/U675P (with autocutter) Service Manual
Confidential
13. Snap fit the lever drive motor detector plate to the gear on the lever drive motor assembly.
When doing so, align the rib on the gear and attach.
14. Lubricate the shaft to which the lever motor reduction gear is attached.
15. Use one E-ring to attach the lever motor reduction gear to the shaft. The arrow on the lever
motor reduction gear should be facing the outside.
Figure 2-61
G-36
Rib
724
E-ring (2.3)
615
Lever motor
reduction gear
614
Lever drive
motor detector plate
To Next Page
Loading...
