Epson TM-U675 - Page 96

2-62 Assembly and Disassembly Rev.D
Confidential
16. Lubricate the inside of the sub slip feed lever shaft in two places.
17. Lubricate the sub slip feed roller holder.
18. Lubricate the form stopper shaft rotating unit in two places.
19. Lubricate the main frame and sub slip feed roller where they contact.
20. Lubricate the form stopper and sub slip feed lever sub assembly shaft where they contact.
21. Lubricate the cam on the lever drive shaft assembly.
Note:
Apply G-48 grease from step 16 to 20 but apply G-36 to the cam in step 21.
Figure 2-62
G-48
G-36
G-48
G-48
G-48
G-48
G-48
Step 20
Step 21
Step 18
Step 19
Step 16
Step 17
Step 19