Epson WorkForce 600 - Page 100

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Removing the Housing 101
Confidential
6. Pull out the Panel FFC through the hole of the Panel Lever.
7. Release the dowels (x2) of the Panel Guide Assy, and remove the Panel Guide
Assy from the Panel Unit..
Figure 4-18. Removing the Panel Unit (3)
8. Remove the Extension Spring of the Panel Lever that secures the Panel Guide
Assy.
9. Release the hook ( ) of the Panel Lever from the Panel Guide Assy.
10. Slide the Panel Cover in the direction of the arrow to remove it.
11. Release the grounding wire from the Panel Lever.
Figure 4-19. Removing the Panel Unit (4)
Panel FFC
Panel Lever
Dowels
Panel Guide Assy
Panel Unit
Grounding wire
hole
Extension Spring
Hook
Groove
Rib and Groove
Grounding wire
Panel Guide Assy
Panel Lever
102
 Route the grounding wire through the three grooves of the
Panel Guide Assy and Panel Lever as shown in
Figure. 4-19.
 Install the Panel Lever, Align the ribs (x2) of the Panel Lever
with the grooves (x2) of the Panel Guide Assy as shown in
Figure. 4-19.
 Install the Panel Unit to the Upper Housing according to the
following procedure.
1. Align the grooves (x2) of the Panel Guide Assy with
the grooves (x2) at the bottom of the Upper Housing.
(Refer to Figure. 4-20.)
Figure 4-20. Installing the Panel Unit
2. Insert the Panel Unit to the Upper Housing with the panel
lock pulled toward upside the printer. (Refer to
Figure.
4-17.)
3. Install the Panel Shafts (x2) into the groove of the Upper
Housing. (Refer to
Figure. 4-16.)
 Route the Panel FFC and grounding wire as shown in Figure.
4-17.
Upper Housing
Panel Guide Assy
Bottom
Panel Unit