Epson WorkForce 600 - ADF PF Roller

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the ADF Unit 148
Confidential
4.7.10 ADF PF Roller
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/ADF Cover Assy/ADF Right Cover/ADF Rear Cover/
ADF Cover Stacker/ADF Document Support Cover/ADF Front Cover/ADF
Document Support Assy/ADF Frame Unit
 Removal procedure
1. Remove the Spur Gear 6.4, Cover Ring and ADF EJ Rear Bush from the ADF
PF Roller.
Figure 4-149. Removing the ADF PF Roller (1)
2. Release the hooks (x2), and remove the ADF EJ Front Bush from the ADF
Frame Unit.
Figure 4-150. Removing the ADF PF Roller (2)
 When setting the cables into the ADF Cable Cover, route them
as shown in the figure below.
Figure 4-148. Routing the cables in the ADF Cable Cover
ADF Motor cable
ADF Sensor cable
ADF Cable Cover
Grounding wire
Align the marked point of ADF
Motor cable, ADF Sensor cable
and grounding wire with the
edge of ADF Cable Cover.
ADF PF Roller
ADF EJ Rear Bush
Cover Ring
Spur Gear 6.4
ADF EJ Front Bush
Hook