Epson WorkForce 600 - CR Motor

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 122
Confidential
4.5.12 CR Motor
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame
 Removal procedure
1. Turn the Spur Gear 51.5 to release the Carriage Lock, and move the CR Unit
to the center.
(Refer to 4.5.1 Printhead Step1 (p109))
2. Release the CR Motor cable from the notches (x3) of the Base Frame and the
hooks (x3) of the Main Frame, and then pull out the cable through the hole of
the Base Frame.
Figure 4-76. Removing the CR Motor (1)
 When installing the PF Motor Assy, pay attention to the
following instructions.
• Insert the dowels (x2) on the Base Frame into the positioning
holes (x2) of the PF Motor
Assy as shown in Figure. 4-74.
• Route the PF Motor Connector Cable as shown in the figure
below.
Figure 4-75. Routing the PF Motor Connector Cable
 Tighten the screws in the order given in Figure. 4-74.
170mm
PF Motor connector cable
C A U T I O N
Be careful not to damage the CR Motor cable when releasing the
cable from the hooks of the Main Frame.
CR Motor Connector Cable
Notch
Hook
Hole