Epson WorkForce 600 - ADF Motor Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the ADF Unit 146
Confidential
3. Remove the screws (x2) securing the ADF Frame Unit.
4. Release the dowel (x1) of the ADF Base Assy and dowels (x2) of the
ADF Frame Unit, and remove the ADF Frame Unit from the ADF Base Assy.
Figure 4-142. Removing the ADF Frame Unit (3)
4.7.9 ADF Motor Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/ADF Cover Assy/ADF Right Cover/ADF Rear Cover/
ADF Cover Stacker/ADF Document Support Cover/ADF Front Cover/ADF
Document Support Assy/ADF Frame Unit
 Removal procedure
1. Release the hooks (x6) of the ADF Cable Cover and open the ADF Cable
Cover, and release the ADF Motor cable, ADF Sensor cable and grounding
wire.
Figure 4-143. Releasing the Cable
 When installing the ADF Frame Unit, align the positioning
holes (x3) of the ADF Frame Unit and ADF Base Assy with the
dowels (x3) for them as shown in
Figure. 4-142.
 Route the ADF Motor cable as shown in Figure. 4-141.
ADF Frame Unit
C.B.P. 3x8, F/Zn-3C (6±1kgfcm)
Positioning hole and dowel
ADF Base Assy
C A U T I O N
When removing the ADF Motor Unit, be cautious not to drop the
gears (x4) of the ADF Frame Unit shown below.
Figure 4-144. Handling the ADF Motor Unit
Hook
ADF Motor Cable
ADF Sensor cable
ADF Cable Cover
Grounding wire
ADF Frame Unit
Do not drop them