Epson WorkForce 600 - Troubleshooting by Error Message

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 50
Confidential
3.3.2 Troubleshooting by Error Message
The following tables provide troubleshooting procedures. Confirm the error message indicated on the LCD, and verify it in the following list for the corresponding troubleshooting
remedy. If some parts need to be replaced or repaired, make sure to follow the procedure given in Chapter 4 “DISASSEMBLY/ASSEMBLY”.
Table 3-4. Check point for Fatal error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Power on
• Anywhere
The Scanner Unit does not initialize when
the power is turned on.
Scanner Motor
1. Check if the Scanner Motor cable is connected to CN11
on the Main Board.
1. Connect the Scanner Motor cable to CN11 on
the Main Board.
2. Check if the coil resistance of the Scanner Motor is about
38Ω*
1
or 43Ω*
2
by using the tester. (refer to Table 3-1).
Note *1: Manufactured by MITSUMI ELECTRIC CO. , LTD.
*2 : Manufactured by Oki Electric Industry Co., Ltd.
2. Replace the Scanner Motor with a new one.
3. Check if the Scanner Motor Connector Cable is damaged. 3. Replace the Scanner Motor with a new one.
Scanner Motor
cable
CN11
Scanner Motor