Epson WorkForce 600 - Error Indications and Fault Occurrence Causes; Error Message List

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 48
Confidential
3.3 Error Indications and Fault Occurrence Causes
3.3.1 Error Message List
You can handle most of the troubles with messages/instructions shown on the LCD panel.
Table 3-3. Error Indications and Fault Occurrence Causes
Error Name LCD Message Error Cause Reference
Fatal error
(System)
A printer error has occurred.
Turn off the printer and turn it on again. See your documentation.
RAM trouble occurs.
System trouble occurs.
Table 3-4. (p50)
Fatal error
(printer mechanism)
Mechanical trouble occurs.
Fatal error
(Scanner)
A scanner error has occurred. Please see your documentation.
Scanner error occurs.
Maintenance request (waste ink over
flow)
The printer's ink pads are at the end of their service life.
Please contact Epson Support.
The waste ink counter exceeds to capacity. Table 3-5. (p56)
Paper jam error
Paper is jammed in the printer. Turn off the printer, open the scanner unit, and
remove the paper.
See your documentation.
Paper stays in the paper path after paper ejection. Table 3-6. (p56)
Ink end error You need to replace the following ink cartridge(s). Ink is out in some I/C.
Table 3-7. (p59)No ink cartridge error The following ink cartridges have not been installed. Install them. No I/C is set.
Incorrect ink cartridge Cannot recognize the following ink cartridge(s). Install them correctly. Incorrect I/C is set.
Ink cartridge cover open error
The ink cartridge cover is open. Open the scanner unit and close the ink
cartridge cover. Press OK to continue.
Ink replacement was attempted with the Ink Cartridge
Cover open.
Table 3-8. (p60)
Paper out error
Paper out.
Load paper and press the Start button.
Failure to load paper to print. Table 3-9. (p60)
Head cleaning
(Ink low error)
Replace the following ink cartridge(s) before cleaning the print head. Head cleaning was attempted in the Ink low status. Table 3-10. (p62)
DSC Direct error Cannot recognize the device.
A device not supported is connected to the port for the
connection of external memory devices.
The DSC demands the current larger than mechanical
limit.
Table 3-11. (p62)