Epson WorkForce 600 - Scanner Carriage Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Scanner Unit 137
Confidential
4.6.3 Scanner Carriage Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Scanner Housing
 Removal procedure
1. Move the Scanner Carriage Unit to the center.
Figure 4-123. Moving the Scanner Carriage Unit
Check the following points when installing the Upper Scanner
Housing.
 Route the grounding wire to the position as shown in the figure
below.
Figure 4-120. Setting position of the grounding wire
 When installing the Upper Scanner Housing, align the inside of
the ribs (x3) on the Upper Scanner Housing with the ribs (x3)
on the Lower Scanner Housing as shown below.
Figure 4-121. Installing the Upper Scanner Housing
Grounding wire
Lower Scanner Housing
Rib
Upper Scanner Housing
C A U T I O N
Do not scratch the Rod Lens Array when removing the Scanner
Carriage Unit.
Figure 4-122. Handling the Scanner Carriage Unit¢
Rod Lens Array
Scanner Carriage Unit