Epson WorkForce 600 - Disassembling the Printer Mechanism; Printhead

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 109
Confidential
4.5 Disassembling the Printer Mechanism
4.5.1 Printhead
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover
 Removal procedure
1. Rotate the Spur Gear 51.5 to unlock the carriage, and move the CR Unit to the
center.
Figure 4-42. Unlocking the Carriage and Moving the CR Unit
2. Open the Cartridge Cover and remove all the ink cartridges from the CR Unit.
 Tighten the screws in the order given in Figure. 4-39.
 Secure the Power Supply Unit Cable with the hook of the Base
Frame as shown in the figure below.
 Put the ferrite core of the Power Supply Unit cable into the
hole of the Base Frame.
Figure 4-41. Routing the Power Supply Unit Cable
Ferrite core
Base Frame
Power Supply Unit Cable
Hook
C H E C K
P O I N T
The Cartridge Cover Hinge must be broken to be removed since the
hinge is permanently-set. When replacing the Printhead, make sure
to replace the Cartridge Cover Hinge with a new one.
Figure 4-43. Cartridge Cover Hinge
CR Unit
Carriage Lock
Spur Gear 51.5
Cartridge Cover Hinge
(top)
Cartridge Cover Hinge
(bottom)