Epson WorkForce 600 - Page 109

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 110
Confidential
3. Cut the Cartridge Cover Hinge with a nipper, and remove the upper half of it
and Hinge Cover Cartridge.
4.
Release the hooks of the lower half of the Cartridge Cover Hinge with
tweezers, and remove the lower half of it. (See
Figure. 4-43 )
Figure 4-44. Removing the Cartridge Cover
5. Release the hook (x1) of the Head Cable Cover with a flathead precision
screwdriver, and remove the Head Cable Cover downward.
6. Release the hook (x1) securing the Ink Guide and remove the Ink Guide.
Figure 4-45. Removing the Head Cable Cover
7. Disconnect the Head FFC (x1) that is connected to the CSIC Board.
8. Release the tabs (x2) securing the Holder Board Assy with a flathead
screwdriver or the like, and remove the Holder Board Assy upward.
Figure 4-46. Removing the Holder Board Assy
9. Remove the Head Cable Inner Cover according to the following procedure.
9-1. Release the hook (x1) and release the rib (1) of the Head Cable Inner
Cover from the Carriage Unit by lifting upward.
9-2. Remove the Rib (2) of the Head Cable Inner Cover from the Carriage
Unit while sliding it in the direction of the arrow.
Figure 4-47. Removing the Head Cable Inner Cover
Cartridge Cover
cutting section
Hinge Cover Cartridge
Hook
Head Cable Cover
Hook
Hook
Ink Guide
Holder Board Assy
Tabs
Head FFC Connector
Head Cable Inner Cover
Hook
Step 9-1
Step 9-2
Rib (1)
Rib (2)
Carriage Unit