Epson WorkForce 600 - MAC Address Setting

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
ADJUSTMENT Using the Adjustment Program (TBD) 161
Confidential
5.2.8 MAC Address Setting
 Overview
EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/
EPSON Stylus SX600FW/ME OFFICE 700FW
have a network function and
stores there MAC address (Media
Access Control Address) in the EEPROM on
the
Main Board. The Main Board supplied as an ASP does not come with the
MAC address written on it, therefore, you
are required to set the MAC address
to the new
Main Board after replacement. The following explains the
procedure.
 Preparation
When replacing the Main Board, make sure to note down the MAC address written on
a label on the MB Upper Shield Plate. If the address is not readable due to
contamination or any other cause, attach a new MAC address label (part code:
1489500) and note down the new address. See
“ 4.4.1 Main Board Unit (p102) ” for
description about the label position.
 Setting flowchart
Figure 5-12. MAC Address Setting Flowchart
C A U T I O N
 When the data of EEPROM on the old Main Board can be read
out, this adjustment is not required.
 To avoid a conflict of MAC address on a network, make sure to
correctly follow the MAC address setting flowchart given on the
right.
 The user should be notified of the change of MAC address
because of the following reasons.
•If the user has set the printer’s MAC address on a router, the
repaired printer with a new MAC address cannot be
connected to the network.
•The default printer name on a network consists of “EPSON”
and the last six digits of the MAC address. Therefore, the
printer name becomes different from the previous one.
C H E C K
P O I N T
You are required to enter the last six digits of the MAC address
(xx:yy:zz) on the Adjustment Program.
MAC address example: 00:00:48:xx:yy:zz
(“xx, yy, zz” represents a value unique to each printer)
Yes
Replace the Main Board with a new one.
Enter the new label MAC address using
the Adjustment Program and set it.
END
Replace the Main Board with
a new one.
END
Is the MAC address on
the label readable?
No
Attach a new MAC address label
on the MB Upper Shield Plate
Enter the MAC address
written on the label using the
Adjustment Program.
START