Epson WorkForce 600 - Front Paper Guide

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 132
Confidential
4.5.18 Front Paper Guide
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper/Main Frame Assy/ASF Unit/Ink System Unit/Star Wheel
Holder Assy/EJ Roller
 Removal procedure
1. Remove the screws (x2) that secure the Front Paper Guide.
Figure 4-105. Removing the Front Paper Guide (1)
2. Release the hook (x1) of the Front Paper Guide, and remove the Front Paper
Guide.
Figure 4-106. Removing the Front Paper Guide (2)
C A U T I O N
When removing the Front Paper Guide, be cautious not to damage
the ribs on the upper surface of the Front Paper Guide.
Figure 4-104. Ribs of the Front Paper Guide
Ribs
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
1
2
Front Paper Guide
 When installing the Front Paper Guide, be cautious not to
damage the PF Roller.
 Install the Front Paper Guide so that the Grounding Spring
comes outside of the hook of the Front Paper Guide.
 Confirm that the leg of the Pad Front Paper Guide is not
caught between the Front Paper Guide and Base Frame.
Figure 4-107. Installing the Front Paper Guide
 Tighten the screws in the order given in Figure. 4-105.
A D J U S T M E N T
R E Q U I R E D
 After replacing the Front Paper Guide, be sure to perform the
required lubrication.
• Chapter 6 “ MAINTENANCE” (p.163)
Front Paper Guide
Hook
Leg of Pad Front Paper Guide
Hook
Grounding Spring
Correct Position
Incorrect Position