Epson WorkForce 600 - Ink System Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 129
Confidential
4.5.17 Ink System Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper/Main Frame Assy/ASF Unit
 Removal procedure
 When installing the ASF Unit, be sure to align the dowels (x2)
of the Base Frame with the positioning holes (x2) of the ASF
Unit as shown in
Figure. 4-94.
 Tighten the screws in the order given in Figure. 4-93.
 When routing the PE Sensor cable, pay attention to the
following instructions.
• Route the cable in the order given in Figure. 4-91.
• Make sure to attach the cable with the blue line facing toward
the Base Frame.
Figure 4-95. Routing PE Sensor Cable
• Check that the cable is tightly routed and there is no slack in
it.
A D J U S T M E N T
R E Q U I R E D
 After replacing the ASF Unit, be sure to perform the required
lubrication.
• Chapter 6 “ MAINTENANCE” (p.163)
PE Sensor Connector Cable
C A U T I O N
When disassembling/assembling the Ink System Unit, pay attention
to the following instructions.
 Be cautious not to get injured with the sharp edges of the
Frame Support.
Figure 4-96. Sharp Edges of Frame Support
 Do not touch or damage the Sealing Rubber or the Head
Cleaner.
 Mark the connecting point before removing the Ink Tube.
Frame Support