Epson WorkForce 600 - Interface; USB Interface; FAX Interface; Network Interface

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
PRODUCT DESCRIPTION Interface 19
Confidential
1.5 Interface
The following is the specifications of the USB Interface, Network Interface, FAX
Interface, and Memory Card Slot mounted on this printer.
1.5.1 USB Interface
The table below describes the specifications of the two USB ports; USB device port for
connecting with a host such as a computer, and the USB host port for connecting with
an external devices such as a DSC (digital still camera).
Note* : External devices that can be connected to the USB device port are:
DSC compliant with the USB Direct Print Protocol specification Rev 1.0
DSC compliant with the CIPA DC-001-2003 (PictBridge) specifications
The “Model Name” is replaced as shown in the following table.
1.5.2 FAX Interface
1.5.3 Network Interface
EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON
Stylus SX600FW/ME OFFICE 700FW can be connected to the network via Wired or
Wireless LAN connection. (They can not be used simultaneously.) The following
describes each Interface.
 Wired LAN
The following interface is equipped for the Wired LAN connection. The
communication mode can be selected from auto setting or fixed setting.
Note* : 10Base-T/100Base-TX Ethernet is supported. MDI/MDI-X is selected automatically.
Table 1-13. USB Interface Specifications
Item USB Device port USB Host port*
Compatible standards
• Universal Serial Bus
Specifications Revision 2.0
• Universal Serial Bus Device
Class Definition for Printing
Devices Version 1.1
• Universal Serial Bus Mass
Storage Class Bulk-Only
Transport Revision 1.0
• Universal Serial Bus
Specifications Revision 2.0
Transfer rate
480 Mbps (High Speed) 480 Mbps (Max.)
Data format
NRZI
Compatible connector
USB Series B USB Series A
Max. cable length
2 [m] or less
Table 1-14. Device ID
When IEEE 1284.4 is Enabled When IEEE 1284.4 is Disabled
@EJL<SP>ID<CR><LF>
MFG:EPSON;
CMD:ESCPL2,BDC,D4,D4PX,ESCPR1;
MDL:Model Name;
CLS:PRINTER;
DES:EPSON<SP>Model Name;
@EJL<SP>ID<CR><LF>
MFG:EPSON;
CMD:ESCPL2,BDC,ESCPR1;
MDL:Model Name;
CLS:PRINTER;
DES:EPSON<SP>Model Name;
Table 1-15. Model Names Indicated in the Device ID
Destination Model Name
North America WorkForce 600
Euro Stylus SX600FW
Euro (Office) Stylus Office BX600FW
Latin/Asia/Pacific Stylus Office TX600FW
China ME Office 700FW
Port Name Connector Description
Line port RJ11 Connects to phone cable from modular wall jack.
EXT port RJ11 Connects to TAM or Telephone.
Table 1-16. Wired LAN
Item Content
Connector RJ-45 receptacle*: 1 port
Communication Speed For either 10Base-T or 100Base-TX, the Full Duplex or Half
Duplex can be selected.