Epson WorkForce 600 - Main Frame Assy

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 124
Confidential
4.5.13 Main Frame Assy
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper
 Removal procedure
1. Release one end of the Extension Spring from the hook of the Main Frame
with longnose pliers, and then remove the spring together with the Driven
Pulley Holder.
Figure 4-79. Removing the Extension Spring and Driven Pulley Holder
2. Move the CR Unit to the left side of the printer.
3. Remove the screw (x1) that secures the LD Shaft Holder.
4. Move the LD Shaft Holder in the direction of the arrow while holding down
its tab with a flathead precision screwdriver, and remove the LD Shaft Holder.
Figure 4-80. Removing the LD Shaft Holder
5. Remove the Extension Springs 10.99 (x3) from each hook of the Main Frame
and the Upper Paper Guide.
Figure 4-81. Removing the Upper Paper Guide (1)
C H E C K
P O I N T
Main Frame Assy consists of the following parts.
 Main Frame
 CR Unit
 Printhead
 Upper Paper Guide
Extension Spring
Driven Pulley Holder
Hook
C.B.P. 3x6, F/Zn-3C (6±1kgfcm)
LD Shaft Holder
Tab
Extension Springs 10.99
Main Frame