Epson WorkForce 600 - Page 124

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 125
Confidential
6. Remove the screws (x6) that secure the Main Frame, and remove it while
avoiding the LD Roller Shaft so as not to hit the Upper Paper Guide.
Figure 4-83. Removing the Main Frame Assy
C A U T I O N
When laying the Main Frame Assy, make sure to put it as shown in the
figure below. Do not lay it with the rollers of the Upper Paper Guide facing
downward, or the rollers or the nozzle surface may get damaged.
Figure 4-82. Precaution on Handling Main Frame Assy
4
3
Main Frame Assy
2
5
C.B.S. 3x6, F/Zn-3C (8±1kgfcm)
Holding Position
C.B.P. 3x8, F/Zn-3C (6±1kgfcm)
1
6
LD Roller Shaft
 When installing the Main Frame Assy, pay attention to the
following instructions.
1. Put the right part of the Upper Paper Guide under the LD
Roller Shaft as shown in the figure below.
2. Align the hook (x1) of the Frame Support with the
positioning hole (x1) of the Main Frame.
3. Align the hook (x1) of the ASF Unit with the positioning
hole (x1) of the Main Frame.
4. Align the dowels (x2) of the Base Frame with the
positioning holes (x2) of the Main Frame.
Figure 4-84. Main Frame Assy
1
LD Roller Shaft
Upper Paper Guide
4
4
3
2