Epson WorkForce 600 - ASF Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 128
Confidential
4.5.16 ASF Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper/Main Frame Assy
 Removal procedure
1. Release the PE Sensor cable from the notches (x6) of the Base Frame and pull
out the cable from the hole (x1).
Figure 4-91. Releasing the PE Sensor Connector Cable
2. Remove the screws (x2) that secure the ASF Unit.
Figure 4-93. Removing the ASF Unit (1)
3. Release the dowel (x1) and dowels (x2) of the Base Frame and the shaft (x1)
of the ASF Unit, then remove the ASF Unit.
Figure 4-94. Removing the ASF Unit (2)
C A U T I O N
When performing the following steps, be cautious not to get injured
with the sharp edges of the Frame Support.
Figure 4-92. Sharp Edges of the Frame Support
1
2
3
4
5 6
7
PE Sensor Connector Cable
Notch
Hole
Frame Support
C.B.P. 3x8, F/Zn-3C (6±1kgfcm)
1
2
ASF Unit
ASF Unit
Dowel
Shaft
Dowels and positioning holes