Epson WorkForce 600 - Front Frame;Right Frame

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 116
Confidential
4.5.6 Front Frame/Right Frame
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Printer Mechanism/
Card Slot Cover/Main Board Unit/Left Frame
 Removal procedure
1. Remove the acetate tape (x2) that secures the Head FFC to the Front Frame.
2. Peel off the ferrite core that secures the Head FFC to the Front Frame.
3. Release the Head FFC from the hooks (x3) of the Front Frame.
4. Remove the Grounding Spring from the Front Frame.
Figure 4-59. Removing the Front Frame/Right Frame (1)
 When installing the Left Frame, take care of the following.
• Make sure to route the PF Encoder FFC through the hole of
the Left Frame, and secure it with a double-sided tape as
shown in Figure. 4-58.
• Make sure to match the dowels of the Base Frame and the
positioning holes of the Left Frame as shown in Figure. 4-58.
 When installing the Left Frame, tighten the screws in the order
given in
Figure. 4-58.
Grounding Spring
Front Frame
Head FFC
Acetate tape
Hook
Double-sided tape
Ferrite core