Epson WorkForce 600 - Wireless LAN Module; Disassembling the Panel Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 105
Confidential
4.4.2 Wireless LAN Module
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/ Middle Cover/Printer
Mechanism/Card Slot Cover
 Removal procedure
1. Remove the screws (x2) securing the Wireless LAN Module.
Figure 4-30. Removing the Wireless LAN Module (1)
2. Disconnect the Wireless LAN Module cable from the connector on the Main
Board (CN13) and remove the Wireless LAN Module from the MB Front
Shield Plate.
Figure 4-31. Removing the Wireless LAN Module (2)
4.4.3 Disassembling the Panel Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover/Panel Unit
 Removal procedure
4.4.3.1 Panel Board/ Panel Board B
1. Remove the screws (x3) securing the Panel Lower Housing.
2. Remove the hooks (x3) of the Panel Unit and remove the Panel Lower
Housing from the Panel Unit.
3. Pull out the Panel FFC and grounding wire through the hole of the Panel
Lower Housing and remove the Panel Lower Housing from the Panel Unit.
Figure 4-32. Removing the Panel Lower Housing
C.B.S. 3x6, F/Zn-3C (4±0.5kgfcm)
Wireless LAN Module
Wireless LAN Module
CN13
MB Front Shield Plate
Panel Lower Housing
C.B.P. 3x12, F/Zn-3C (6±1kgfcm)
Positioning hole and Hook
Hole
Panel FFC
Grounding wire