Epson WorkForce 600 - Page 105

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 106
Confidential
4. Remove the screws (x5) securing the Panel Board Frame, and remove the
grounding wire.
5. Peel off the Panel FFC from the Panel Board Frame and remove the Panel
Board Frame in the direction of the arrow.
Figure 4-33. Removing the Panel Board Frame
6. Disconnect the LCD FFC from the connector on the LCD Board.
7. Disconnect the Panel FFC from the connector on the Panel Board B.
8. Release the hook (x1) of the Panel Cover and remove the Panel Board and
Panel Board B.
Figure 4-34. Removing the Panel Board/ Panel Board B
4.4.3.2 LCD Module/ LCD Cover
1. Remove the Panel Board and Panel Board B.
(Refer to "4.4.3.1 Panel Board/ Panel Board B (p105)")
2. Remove the screws (x2) securing the LCD Module and remove the LCD
Module from the Panel Cover.
3. Peel off the LCD Cover from the Panel Cover.
Figure 4-35. Removing the LCD Module/ LCD Cover
C A U T I O N
When removing the Panel Board Frame, do not damage the cable
shown in
Figure. 4-33 with the Panel Board Frame.
Panel Board Frame
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
Positioning hole and dowel
Double-sided tape
C A U T I O N
Cable
Grounding wire
Screw it with the grounding wire.
Panel FFC
LCD FFC
Panel Board B Panel Board
LCD Board
Hook
Positioning hole and dowel
Panel Cover
 When installing the Panel Board and Panel Board B, make sure
to match the positioning holes (x4) with their positioning pins of
the Panel Cover as shown in
Figure. 4-34.
 When installing the Panel Board Frame, align the positioning
holes (x2) of the Panel Board Frame with the dowels (x2) of the
Panel Cover as shown in
Figure. 4-33.
 When installing the Panel Lower Housing, tighten the screws
after aligning the positioning holes (x3) of the Panel Lower
Housing and the hooks (x3) of the Panel Cover as shown in
Figure. 4-32.
When installing the LCD Module, be sure to keep out dust between
the LCD Cover and LED Module.
LCD Cover
LCD Module
C.B.P. 2x6, F/Zn-3C (6±1kgfcm)
Double-sided tape
Panel Cover