Epson WorkForce 600 - Star Wheel Holder Assy

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 118
Confidential
4.5.7 Star Wheel Holder Assy
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover
 Removal procedure
1. Remove the Grounding Spring from the Star Wheel Holder Assy.
2. Remove the screws (x2) that secure the Star Wheel Holder Assy, and remove
the Star Wheel Holder Assy.
Figure 4-65. Removing the Star Wheel Holder Assy
 When installing the Front Frame, pay attention to the
following instructions.
• As shown in Figure. 4-62, be sure to secure the Front Frame
with the hook (x1) and the cutouts (x2).
• As shown in Figure. 4-61 secure the Front Frame and Right
Frame together with the screw. (Place the Right Frame on top
of the Front Frame.)
 Secure the Head FFCs (x3) to the Front Frame with the acetate
tape (x1) as shown in the figure below.
Figure 4-64. Acetate tape position
Acetate tape (40mm)
Bending point of Head FFC
Align the edge of the Front
Frame with the bending
point of the Head FFC, and
secure the FFC with the
acetate tape.
C.B.P. 3x8, F/Zn-3C (6±1kgfcm)
Star Wheel Holder Assy
Grounding Spring