Epson WorkForce 600 - Chapter 4 DISASSEMBLY;ASSEMBLY; Upper Scanner Housing

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Scanner Unit 136
Confidential
7. Lift the rear side of the ADF Unit and release the hook (x1) of the ADF Cable
Cover from the hole of the Scanner Unit.
8. Pull out the cables of the ADF Unit through the hole of the Scanner Unit, and
remove the ADF Unit.
Figure 4-117. Removing the ADF Unit (2)
4.6.2 Upper Scanner Housing
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit
 Removal procedure
1. Remove the screws (x7) securing the Upper Scanner Housing and remove the
Upper Scanner Housing.
Figure 4-119. Removing the Upper Scanner Housing (1)
 Route the ADF Sensor cable and ADF Motor cable as shown in
the figure below before installing the Scanner Cable Cover.
Figure 4-118. Routing the ADF Cable
 When installing the Scanner Cable Cover, first insert the rib
of the Scanner Cable Cover shown in Figure. 4-114 to the
Lower Scanner Housing, then tighten the screw.
ADF Unit
ADF Cable Cover
Hook
Hole
Route the ADF Sensor cable
over the ADF Motor cable
and hook it on the rib.
Fold the ADF
Sensor cable here.
C A U T I O N
 Following work should be performed in a room where there is
a little dust. A clean room or a clean bench would be
preferable.
 Do not scratch the Rod Lens Array when removing the CIS
Assy.
C.B.P. 3x10, F/Zn-3C (5±1kgfcm)
Top
Upper Scanner Housing
Bottom