Epson WorkForce 600 - Power Supply Unit

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 108
Confidential
4.4.4 Power Supply Unit
 Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/ Middle Cover/Printer
Mechanism/Card Slot Cover
 Removal procedure
1. Disconnect the connector of the Power Supply Unit (CN23) on the Main
Board.
2. Remove the Power Supply Unit cable from the hook of the Base Frame.
Figure 4-38. Removing the Power Supply Unit (1)
3. Remove the screws (x2) that secure the Power Supply Unit.
4. Lift the Base Frame a little and remove the Power Supply Unit.
Figure 4-39. Removing the Power Supply Unit (2)
CN23
Power Supply Unit Cable
Hook
Base Frame
 Insert the tabs (x2) of the Power Supply Unit into the holes on
the Base Frame.
Figure 4-40. Installing the Power Supply Unit
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
1
2
Power Supply Unit
Power Supply Unit
Ribs
Base Frame