Epson WorkForce 600 - Page 129

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 130
Confidential
1. Detach the Waste Ink Tube (x2) together with the Tube Stopper from the
Waste Ink Cover.
2. Detach the Waste Ink Tube (x2) from the groove of the Base Frame.
Figure 4-97. Detaching Waste Ink Tube
3. Remove the screw (x1) that secures the Ink System Unit.
4. Slide the Ink System Unit in the direction of the arrow while releasing the
hook with a flathead precision screwdriver or a similar tool, and remove the
Ink System Unit.
Figure 4-98. Removing the Ink System Unit
Waste Ink Cover
Tube Stopper
Groove
Waste Ink Tube
C.B.P. 3x6, F/Zn-3C (6±1kgfcm)
Ink System Unit
Hook
 If the Carriage lock lever comes off, reassemble it following the
steps below.
1. Attach the one end of the Extension Spring 0.8 to the hook
of the Carriage Lock Lever.
2. Attach the other end of the Extension Spring 0.8 to the Ink
System Unit.
3. Insert the dowel (x1) of the Carriage Lock Lever into the
hole (x1) of the Ink System Unit.
Figure 4-99. Installing the Carriage Lock Lever
Carriage Lock Lever
Extension Spring 0.8
Ink System Unit
Dowel and Hole