Epson WorkForce 600 - Page 130

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 131
Confidential
 When installing the Ink System Unit, pay attention to the
following instructions.
• Align the dowels (x3) of the Ink System Unit with the
positioning holes (x3) of the Base Frame.
Figure 4-100. Installing the Ink System Unit (1)
• Align the ribs (x2) of the Ink System Unit with the grooves (x2)
of the Base Frame.
Figure 4-101. Installing the Ink System Unit (2)
1
2
3
Base Frame Side
1
2
3
Ink System Side
Ink System Unit
Rib and Groove
 Place the tube with a red line to the rear as shown below, and
route the waste ink tubes (x2) without any twisting.
Figure 4-102. Routing the Waste Ink Tube
 Attach the Tube Stopper to the Waste Ink Tube as shown in
the figure below, and insert them into the Waste Ink Cover.
Figure 4-103. Installing the Waste Ink Tube
Waste Ink Tube
Groove
Red line
Groove
Blue line
Align the blue markings of
Waste Ink Tube with the edge
of the hook (the one from the
rear side of the printer) on the
Ink System.
35 ± 1mm
40 ± 1mm
Tube Stopper
Waste Ink Tube