Epson WorkForce 600 - Page 110

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 111
Confidential
10. Remove the screws (x3) that secure the Printhead, and lift the Printhead with
longnose pliers.
Figure 4-48. Removing the Printhead (1)
11. Disconnect the Head FFC from the connectors (x3) of the Printhead, and
remove the Printhead.
Figure 4-49. Removing the Printhead (2)
C A U T I O N
Do not touch or damage the nozzles or the ink supply needles of the
Printhead.
C.B.S. 2.5x8, F/Zn-3C (3±1kgfcm)
1
2
3
Printhead
Head FFC
 Tighten the screws in the order given in Figure. 4-48.
 Insert the Holder Board Assy vertically into the CR Unit so as
not to put the Holder Board Assy on the rib of the Printhead.
A D J U S T M E N T
R E Q U I R E D
Whenever the Printhead is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 “ ADJUSTMENT” (p.150)