Epson WorkForce 600 - Page 154

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
ADJUSTMENT Adjustment Items and Overview 155
Confidential
Note : <Meaning of the marks in the table>
“O” indicates that the adjustment must be carried out. “O*” indicates that the
adjustment is recommended. “---” indicates that the adjustment is not required.
If you have removed or replaced multiple parts, make sure to check the required
adjustments for the all parts. And when multiple adjustments must be carried out, be
sure to carry out them in the order given in the “Priority” row.
ASF unit
Remove
--- --- --- --- --- --- --- O O --- --- --- --- --- O O O
Replace
--- --- --- --- --- --- --- O O --- --- --- --- --- O O O
CR unit
Remove
--- --- --- --- --- --- --- O O O O --- --- --- O O O
Replace
--- --- --- --- --- --- --- O O O O --- --- --- O O O
Upper paper guide
Remove
--- --- --- --- --- --- --- O --- --- --- --- --- --- O O O
Replace
--- --- --- --- --- --- --- O --- --- ---
O
Reset to 0
--- --- O O O
Front paper guide unit
Remove
--- --- --- --- --- --- --- O* --- O O --- --- --- O O O
Replace
--- --- --- --- --- --- --- O* --- O O --- --- --- O O O
PF roller
Remove
--- --- --- --- --- --- --- O* --- --- --- --- --- --- O O O
Replace
--- --- --- --- --- --- --- O* --- --- --- --- --- --- O O O
Waste ink pad
Remove
--- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- ---
Replace
--- --- --- O --- --- --- --- --- --- --- --- --- --- --- --- ---
Table 5-4. Required Adjustment List
Priority
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
EEPROM data copy
Initial setting
USB ID input
Waste ink pad counter
MAC address setting
Ink charge
Head ID input
Top margin adjustment
First dot position adjustment
Head angular adjustment
Bi-D adjustment
Initialize
PF deterioration offset/
Disenable PF
deterioration offset
CR motor heat
protection control
PF motor heat
protection control
PF adjustment
PF band adjustment
Bottom margin adjustment
Adjustment Item
Part Name
C A U T I O N
 When the EEPROM data copy is impossible with the main
board that needs to be replaced, the Waste Ink Pad must be
replaced after replacing the main board with a new one.
 After all required adjustments are completed, use the “Final
check pattern print” function to print all adjustment patterns
for final check. If you find a problem with the printout patterns,
carry out the adjustment again.
 When using a new main board for replacing the Printer
Mechanism, the Initial setting must have been made to the main
board.