Epson WorkForce 600 - Page 66

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 67
Confidential
Table 3-20. Check point for ADF Paper Jam error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Power on
•–
After turning on the power and the
initialization process completes, an error
is indicated on the LCD panel.
ADF Cover Assy
1. Check if the ADF Cover Assy is opened. 1. Close the ADF Cover Assy.
• Operation
• Before ADF PF
Roller
The document is fed, but the reading
process does not starts, and an error is
indicated.
ADF PE Sensor
1. Check if the ADF Sensor Cable is connected to CN18 on
the Main Board.
1. Connect the ADF Sensor Cable to CN18 on the
Main Board.
2. Check if the ADF Sensor Cable is damaged. 2. Replace the ADF Frame Assy with a new one.
ADF PE Sensor
Lever
1. Check if the ADF PE Sensor Lever is deformed or
damaged.
1. Replace the ADF Frame Assy with a new one.
ADF PF Roller
1. Check if the Spur Gear 6.4 is correctly attached to the
ADF PF Roller.
1. Attach the Spur Gear 6.4 correctly.
ADF Sensor Cable
CN18
ADF PE Sensor Lever
ADF Frame Assy
ADF PF Roller
Spur Gear 6.4