❏ Clean the inside of the ADF.
❏ Do not load above the line just under the
d
symbol inside the ADF edge guide.
❏ Check that the ADF icon appears on the control panel. If it does not appear, place the originals again.
Related Information
&
“Available Originals for the ADF” on page 31
& “Placing Originals on the ADF” on page 31
& “Cleaning the ADF” on page 90
Power and Control Panel Problems
Power Does Not Turn On
❏ Hold down the
P
button for a little longer.
❏ Make sure the power cord is securely plugged in.
Power Does Not Turn O
Hold down the
P
button for a little longer. If you still cannot turn
o
the printer, unplug the power cord. To
prevent the print head from drying out, turn the printer back on and turn it o by pressing the
P
button.
LCD Screen Gets Dark
e printer is in sleep mode. Press any button on the control panel to return the LCD screen to its former state.
Printer Does Not Print
Check the following if the printer does not operate or prints nothing.
❏ Connect the interface cable securely to the printer and the computer.
❏ If you are using a USB hub, try to connect the printer directly to the computer.
❏ If you are using the printer over a network, make sure the printer is connected to the network. You can check
the status by checking the indicators on the control panel or by printing the network status sheet. If the printer
is not connected to the network, see the Network Guide.
❏ If you are printing a large image, the computer may not have enough memory. Print the image at a lower
resolution or a smaller size.
User's Guide
Solving Problems
114
To Next Page
Loading...
Need help?
General
